After programming, module BEEPS when activated (USB / DIY Modules and tags, excluding soundBOX)

After programming, module BEEPS when activated (USB / DIY Modules and tags, excluding soundBOX)

How to fix a USB/DIY module that BEEPS when activated.
  1. Did the sound loader software say "write success" (at the bottom of the window)?  If not, please try programming again and ensure that the software says "write success" when finished.

  2. Does the sound loader software say "Version:1.2.1.0" at the bottom right of the download window? If not, then if you click on the red icon on the top-left of the sound loader window, then click "About LX Sound Loader...", does it say "...Version 1.0"? For this module, you will need to be using Version 1.2.1.0.  Please download and install the correct version of the sound loader software.  The download page can be found here https://bigdawgsgreetings.com/soundloader-download/)


    • Related Articles

    • Decibel Level - Sound Module & Sound Box

      Please see the photos below of the decibel (dB) levels for a sound module and a soundBOX.  Note that dB levels will vary in both cases depending on installation, the sound file loaded, etc. ​

    • NFC Programming Instruction with NXP Tagwriter

      Download NFC TagWriter by NXP (Google Play link https://play.google.com/store/apps/details?id=com.nxp.nfc.tagwriter&hl=en_CA or Apple App Store https://apps.apple.com/us/app/nfc-tagwriter-by-nxp/id1246143221) Open app and follow the directions below ...

    • Make volume louder (USB / DIY Modules)

      On our sound modules, there no volume control on the module itself, or in the sound loader software.  The only way to increase the volume is to amplify the sound file itself. If your sound is too soft, you can use sound editing software to adjust ...

    • Error: USB device open failed / Cannot Start - Code 10 (USB / DIY Modules)

      Error Messages: USB device open failed. Assume 8Mbit SPI Flash size. Cannot start - Code 10 (Windows 8 or 10) Are you using Windows 8 or 10?  As mentioned in the listing and sound loader download page, some users have difficulties with certain ...

    • "Write SPI flash error" or Sound loader freezes when writing (USB / DIY Modules)

      Errors: Write SPI flash Error... (Program freezes or hangs after the "write" button is clicked) Cause: Sampling Rate setting is set too high, or the sound file duration is too long. Remedy: Choose a lower sampling rate setting. Cut the sound file ...