"Write SPI flash error" or Sound loader freezes when writing (USB / DIY Modules)

• Related Articles

• Error: USB device open failed / Cannot Start - Code 10 (USB / DIY Modules)

  Error Messages: USB device open failed. Assume 8Mbit SPI Flash size. Cannot start - Code 10 (Windows 8 or 10) Are you using Windows 8 or 10?  As mentioned in the listing and sound loader download page, some users have difficulties with certain ...

• After programming, module BEEPS when activated (USB / DIY Modules and tags, excluding soundBOX)

  How to fix a USB/DIY module that BEEPS when activated. Did the sound loader software say "write success" (at the bottom of the window)?  If not, please try programming again and ensure that the software says "write success" when finished. Does the ...

• Make volume louder (USB / DIY Modules)

  On our sound modules, there no volume control on the module itself, or in the sound loader software.  The only way to increase the volume is to amplify the sound file itself. If your sound is too soft, you can use sound editing software to adjust ...

• Decibel Level - Sound Module & Sound Box

  Please see the photos below of the decibel (dB) levels for a sound module and a soundBOX.  Note that dB levels will vary in both cases depending on installation, the sound file loaded, etc. ​

• Sound Module will not record, will not play, and appears dead

  Please try the following and let us know the result: Make sure you remove the plastic tab from underneath the slider switch. Make sure there is no obstruction between the slider switch metal contacts.  Clean off any debris if necessary. While laying ...