Sound Module Recording Instructions/Slider Install

• Related Articles

• Sound Module will not record, will not play, and appears dead

  Please try the following and let us know the result: Make sure you remove the plastic tab from underneath the slider switch. Make sure there is no obstruction between the slider switch metal contacts.  Clean off any debris if necessary. While laying ...

• Decibel Level - Sound Module & Sound Box

  Please see the photos below of the decibel (dB) levels for a sound module and a soundBOX.  Note that dB levels will vary in both cases depending on installation, the sound file loaded, etc. ​

• Greeting Card / Frame Card will not record

  With the card fully open, you can press the record button to activate the recording feature. Place your card open and flat on a table with the microphone (located on the inner right panel of the card) facing you. Do not move the card while recording, ...

• "Write SPI flash error" or Sound loader freezes when writing (USB / DIY Modules)

  Errors: Write SPI flash Error... (Program freezes or hangs after the "write" button is clicked) Cause: Sampling Rate setting is set too high, or the sound file duration is too long. Remedy: Choose a lower sampling rate setting. Cut the sound file ...

• Changing of speaker / Connecting module to an amplifier (line-in) or amplified speaker

  For our eBay and online store, we do not make or support modifications to the items we sell.  However, if you have or know someone with basic electronics knowledge and skill, you can easily change the speaker with another (larger) one. Our sound ...